Remote Controlled Solar Alarm Lamp

Instruction:

• 1. The first time you press the ON/OFF switch (remote control A key), the product will emit "beep" sound, it will enter the 24-hour sound and light alarm mode; it will slow flash at intervals for about 30 seconds (the product is to be activated during this time, it will not emit sound alarm), and then enter the active state.
• 2. Press the ON/OFF switch for the second time (remote control B button), the product will emit a "beep" sound, it will enter a 24-hour flashing and silent alarm mode (only flashing, no sound); the product will slow flash 2 times at intervals for about 30 seconds, and then enter the active state.
• 3. Press the ON/OFF switch for the third time (remote control C button), the product will emit a "beep" sound, it will enter the night sound and light alarm mode (not working during the day, only working at night); the product will flash 3 times at intervals for about 30 seconds.
• 4. Press the ON/OFF switch for the fourth time (remote control D button), the product will emit a "beep" sound, it will enter the night flashing and silent alarm mode (only flashing, no sound); the product will flash 4 times at intervals for about 30 seconds.
• 5. Press the ON/OFF switch for the fifth time to turn off; or long press any key on the remote control for 5 seconds to turn off.

Remote Control CODE Instruction: (Wireless Signal Frequency 433MHZ)

• 1. The remote control has already been set in the factory, it can be used directly. Please be cautious to use this function if you don't need to change it.
• 2. When there are many interference signal sources in the environment, it will affect the correct code matching. It is recommended to repeat the code matching in the place with less interference signal sources until the code matching is successful.
• 3. Press ON/OFF button on the lamp for about 5 seconds until all the LEDs are fully lit (a "beep" prompt will be heard during the period), then the remote control enters into the state of waiting to receive the remote control command (if there is a beep before you press the remote control key, it means there are other interfering signals, you need to wait until the light of the remote control goes out and then re-code), then long press A, B, C, keys on the remote, when there is another beep sound, the code is completed, the lamp automatically turns off the lights.
• 4. If you need to use one remote control to match more than one unit, you need to turn on each light one by one to match the code.
• 5. After successful code, don't forget to press keys onremote control to check if the function of each button is correct.